production
Skip to Content

EG2011: PROCESS ENGINEERING (2018-2019)

Last modified: 22 May 2019 17:07


Course Overview

A general engineering course that provides insight into the two main conservation principles, mass and energy. Processes are usually described through block diagrams. This language, common to many disciplines in engineering, helps the engineer to look at their processes with an analytical view. Degree of freedom analysis is addressed, emphasising its importance to solve a set of linear equations that model fundamental balances of mass. Practical examples of Energy balances are displayed, bringing Thermodynamics to a practical level. Heat Transfer is introduced. Process control is introduced, explaining basic control techniques and concepts, i.e sensors, feedback, control loops and PID controllers.

Course Details

Study Type Undergraduate Level 2
Session First Sub Session Credit Points 15 credits (7.5 ECTS credits)
Campus None. Sustained Study No
Co-ordinators
  • Dr David Vega-Maza

Qualification Prerequisites

  • Either Programme Level 1 or Programme Level 2

What courses & programmes must have been taken before this course?

What other courses must be taken with this course?

None.

What courses cannot be taken with this course?

  • EG2002 Process Engineering (Studied)
  • EG2580 Chemical Engineering Fundamentals (Studied)

Are there a limited number of places available?

No

Course Description

This course covers the fundamental tools of sensing and instrumentation that are currently used by both engineers and scientists.  The transversal science of metrology is discovered, focused on uncertainty analysis and calibration.  A range of sensor technologies is then investigated with emphasis on the underlying physical principles.  Electronic circuits for the capture of sensor signals are considered, along with limitations such as noise.  The course explores instrumentation systems including wireless sensor networks (WSN) and micro-electromechanical systems (MEMS).


Contact Teaching Time

Information on contact teaching time is available from the course guide.

Teaching Breakdown

More Information about Week Numbers


Summative Assessments

1st Attempt: 2hr written examination (80%); continuous assessment (20%).

Resit: 3hr written examination (100%).

Formative Assessment

There are no assessments for this course.

Feedback

Students receive whole-class feedback via MyAberdeen.  Active participation is sought through a discussion board in MyAberdeen

 

Course Learning Outcomes

None.

Compatibility Mode

We have detected that you are have compatibility mode enabled or are using an old version of Internet Explorer. You either need to switch off compatibility mode for this site or upgrade your browser.